BMW Services

Expert Car Maintenance For BMW Vehicles

At S&S Motors Inc., we are proud to be able to provide comprehensive service and repairs for your BMW vehicle. Our investment in training and equipment over the years has enabled us to offer dealership capabilities with the personal service and attention that we take pride in. Listed below is a summary of the services and repairs we are pleased to offer our BMW clients.

Maintenance Services

  • BMW recommended scheduled maintenance
  • Dealer approved synthetic oil, lube and filter service
  • Indicator based maintenance and services
  • Fluid services with BMW approved fluids
  • PCV and oil separator replacement
  • Tire sales, mounting and balancing (including run flat tires) and seasonal storage is available
  • Fuel injection system service

Repair Services

  • All warning indicator and engine / driveability diagnostics
  • Brake and ABS system diagnosis and repair
  • Steering and Suspension diagnostics and repair
  • Air conditioning and heating system diagnostic and repair
  • Exhaust and muffler systems
  • Electrical and charging systems diagnosis and repair
  • Clutch and Dual mass flywheel replacement
  • Pre-purchase inspections and DOT safety certification

Suspension

At the heart of every BMW’s performance is it’s handling and how well a BMW handles is directly influenced by its suspension. The BMW performance suspension lets you savour every curve and corner like never before. Installing top quality OEM parts and finishing with state of the art computerized alignment, our BMW specialized technicians will have you racing off with a smile from ear to ear.

Brakes

Our Brake service includes: full brake inspections, brake pad, rotor and sensor replacement, and caliper repair or replacement. We service all BMW models 1,3,5,6 and 7 models, X series, X3, X5, X6, Z6 models and all M models. At S&S Motors our technicians and service advisor will have you and your BMW back on the road in no time. Just as your BMW is important to you, it’s important to us and will be treated as if it were our own.

Cooling System

Often neglected service on many vehicles is the maintenance of the cooling system. In general BMW recommends that you flush and clean your vehicles cooling system once every 36 months or every three years. A properly maintained cooling system must have a few things for proper operation. An adequate supply of coolant, a radiator that acts as a heat exchanger with the outside air, a fan or flow source, a water pump to keep up circulation and a thermostat to regulate the engine at its optimum operating temperature. The coolant must also have the correct mixture and chemical compound to promote heat transfer, protect against freezing and also inhibit corrosion.

A/C

Our professional BMW A/C repair and maintenance team can check to ensure your vehicles A/C system is running at peak performance. Diagnosing and repairing all of your concerns from warm air blowing through the vents to none at all, our trained technicians will isolate and repair your BMW’s air condition system with confidence and care.

Oil

One of the most important services is replacing your engine oil and filter. Frequent oil changes are vital to prolonging the life of your engine. Even though BMW recommends oil change intervals that are very far apart, we highly recommend that you replace your engine oil every 8,000-10,000 km’s or at least twice a year if you’re not reaching the mileage. The professional team at S&S Motors can give you their expert advice and keep you on a proper maintenance schedule to keep your BMW happy and healthy.

PCV / Breather System

This system assures only clean, filtered air is drawn in to the engine. A clogged system prevents the PCV System from siphoning away the blow by gases and moisture created by engine combustion resulting in oil break down and sludge build up. Blockage will cause all sorts of engine misfires and rough running.

Tune Up

Tune up is an old fashioned maintenance term that’s nearly non-existent today. With electronic ignition and fuel injection, came computers that look over engine control settings. Today’s engine requires advanced diagnostic equipment and training for proper isolation and repair. Proper maintenance is always the best route for peak performance and longevity.